Underwater Cameras Underwater Cameras
Underwater Cameras

Snap Sights Daylight Waterproof Dive Camera

About Us
Snap Sights Underwater Camera

The waterproof housing is warranted for its first use only. If opened and resealed carefully it may be reused. Due to potential consumer resealing errors, such reuse is at consumer's risk.

  1. Reloading Intructions

    Abuse or misuse of product is not covered under warranty. Special care must be taken when using waterproof products.

    1) Lift safety catch on cam lock and twist the cam lock to the open position. Gently open housing and remove camera Press film release button (at bottom of camera).

    2) Wind rewind lever (at top of camera) in clockwise direction until film winds free.

    3) Lift rewind lever to release film from camera.

    4) Remove red sticker and open back of camera to remove exposed film.

    5) Insert new film and extend film tip to the right hand winding spool. Make sure holes in film are aligned with wind sprocket gear teeth.

    6) Close back of camera and replace red sticker.

    7) Advance film to #1 in the frame counter on top of camera. (If the counter does not advance film is not loaded correctly, repeat step 6).

    8) Make sure that the O-ring seal is clean of sand, dirt or other debris.

    9) Align camera in housing, close back and twist cam lock to closed position.

To find out more about the Snap Sights Daylight Waterproof Dive camera reloading instructions, please contact us.

underwatercameras.com.au  —  PO Box 362, Manunda, Queensland 4870, Australia
p: 07 4031 9266 (international: +61 7 4031 9266)
f: 07 4031 9277 (international: +61 7 4031 9277)
e: info@underwatercameras.com.au
web design by cityofcairns.com